Pull Type Slave Cylinders
Pull Type Slave Cylinders - Feature Image

Pull Type Slave Cylinders

AP Racing offer a Pull Type Slave Cylinder suitable for use with CP7562, CP7223, CP7224 & CP7923 families of pull type racing clutches.

These Slave Cylinders are lightweight hydraulically self contained units that mount on the back of the engine block using 3 studs/sleeves, and operate the clutch directly.

The one piece aluminium alloy body is light weight and compact, the units feature high temperature seals and a special hard wearing low friction coating on all sealing surfaces.

The release bearing is included with the slave cylinder, however unlike the push type units the release fulcrum is supplied with the clutch not the slave cylinder.

General Information:
Ensure that the unit is installed in the correct position, with bleed port uppermost as shown on the installation drawing.
All fittings intended to seat at the bottom of the hydraulic ports must have an included angle of 90°. Click on part number below for more information.

Contact us today if you need any help finding the right product for you +44 (0) 24 7663 9595