CP3759 Family - NOTE - INFORMATION ONLY - NO LONGER AVAILABLE TO ORDER
IMPORTANT NOTE:
CP3759 TYPE SLAVE CYLINDERS HAVE BEEN MADE OBSOLETE AND THEREFORE ARE NO LONGER AVAILABLE TO ORDER. THERE ARE NO RPELACEMENTS. THE INFORMATION DETAILED WILL REMAIN FOR REFERENCE / GUIDANCE PURPOSES ONLY.
- A Reconditioning service is still available for replacement pistons and bearings.
he CP3759 series concentric slave cylinder is a lightweight, hydraulically self-contained unit with high temperature seals. All sealing surfaces are protected by a hard wearing / low friction coating which helps prolong seal life.
Features:
- Aluminium Alloy Body.
- Aluminium alloy Piston.
- 18mm Max Stroke.
- Use with PRF660, 600 or other high quality brake fluids.
- Cylinders are supplied with release bearing in a choice of three fulcrum diameters.
- Hydraulic Fitting kits available for -3 or -4 aeroquip:
- 7/16" (Steel adaptor) for - 4 aeroquip - CP3759-6
- 3/8" (Steel adaptor) for -3 aeroquip - CP3759-5
- Fittings to be tightened to 28Nm (21ft/lb)
Available Part Numbers:-
- CP3759-38 = Ø38mm Fulcrum.
- CP3759-50 = Ø50mm Fulcrum.
- CP3759-54 = Ø54mm Fulcrum.
General Information:
Ensure that the unit is installed in the correct position, with the bleed port uppermost as shown in the installation drawings (below). all fittings intended to seat at the bottom of the hydraulic ports must have an included angle of 90°.
NOTE:
When large diameter splines are used please check clearance of the spline in the slave cylinder body. Larger splines also have an increased driven plates hub boss. Please check the clearance of the driven plates at maximum slave travel. See the clutch installation drawing for details.
CP3759 TYPE SLAVE CYLINDERS HAVE BEEN MADE OBSOLETE AND THEREFORE ARE NO LONGER AVAILABLE TO ORDER. THERE ARE NO RPELACEMENTS. THE INFORMATION DETAILED WILL REMAIN FOR REFERENCE / GUIDANCE PURPOSES ONLY.
- A Reconditioning service is still available for replacement pistons and bearings.
he CP3759 series concentric slave cylinder is a lightweight, hydraulically self-contained unit with high temperature seals. All sealing surfaces are protected by a hard wearing / low friction coating which helps prolong seal life.
Features:
- Aluminium Alloy Body.
- Aluminium alloy Piston.
- 18mm Max Stroke.
- Use with PRF660, 600 or other high quality brake fluids.
- Cylinders are supplied with release bearing in a choice of three fulcrum diameters.
- Hydraulic Fitting kits available for -3 or -4 aeroquip:
- 7/16" (Steel adaptor) for - 4 aeroquip - CP3759-6
- 3/8" (Steel adaptor) for -3 aeroquip - CP3759-5
- Fittings to be tightened to 28Nm (21ft/lb)
Available Part Numbers:-
- CP3759-38 = Ø38mm Fulcrum.
- CP3759-50 = Ø50mm Fulcrum.
- CP3759-54 = Ø54mm Fulcrum.
General Information:
Ensure that the unit is installed in the correct position, with the bleed port uppermost as shown in the installation drawings (below). all fittings intended to seat at the bottom of the hydraulic ports must have an included angle of 90°.
NOTE:
When large diameter splines are used please check clearance of the spline in the slave cylinder body. Larger splines also have an increased driven plates hub boss. Please check the clearance of the driven plates at maximum slave travel. See the clutch installation drawing for details.